I have been having a few issues with Freedom Scientific's JAWS screen reader. There is a free demo located here:
http://www.freedomscientific.com/downloads/jaws/jaws-downloads.asp
After the setup capture is finished there are 2 warnings displayed:
A new kernelmode component "powerBraille System Driver" was installed, this is not supported by ThinApp
A new kernelmode component "Sentinel" was installed, this is not supported by ThinApp
There is also a mesage that is displayed after the thinapp is run on a test machine which I was not shown during the capture:
I know that drivers aren't supported during the capture; so I installed them prior to the capture.
I noticed though that there are 2 files which are installed into the drivers folder but I can't install them seperately (may very well be down to my lack of knowledge - hence me posting here): powerbrl.sys & sentinel.sys
These certainly point to the above warnings but I am at a loss as to how I can install these seperately prior to the setup capture. Any help or pointers will be greatly appreciated.
Thanks in advance.